HAVER & BOECKER provides a comprehensive range of accessories relating to all test sieves for dry- and wet-sieving in a short time.
Sieve covers defend stored test sieves from dirt and dust. They are also used for storing of classified material in single test sieves and sieve towers. We offer sieve covers for all test sieves made from stainless steel and beechwood.
Sieve pan for dry and wet sieving
Sieve pans collect the sieve underflow of bulk material. These are the fine particles. Please note that you need test sieves with discharge nozzle for wet sieving. Sieve pans with diameters up to 203 mm are equipped with bevel bottoms, larger sieve pans made from stainless steel with plane bottoms.
Intermediate ring and intermediate pan
We offer intermediate rings and intermediate pans for all test sieves made from stainless steel. Intermediate rings are used together with less than three test sieves to increase the sieve tower as you need a specific height for HAVER Test Sieve Shakers. By using intermediate pans more than one sieve analysis can be simultaneous done with one test sieve shaker.
Additional pasted seam
You prevent fixing of particles between woven wire cloth and tension ring of a test sieve by choosing an additional pasted seam above or below the woven wire cloth.
Normally every HAVER Test Sieves with frames made from stainless steel are equipped with a PVC sealing ring, which is temperature-resistant until approx. 130°C. On demand we deliver your test sieve with a VITON sealing ring (heat resistance from -15°C up to +200°C).
Rubber balls and rubber cubes
Rubber balls and rubber cubes belong to products for sieving support. They are placed on the test sieve and clean the aperture sizes during the sieving process to speed it up.
The sieve holder with its space-saving design can easily be fitted in many versions and enables up to five test sieves with diameter of 200 mm or 203 mm be stored in safety. Due to single labels you can identify the test sieve at a glance.
HAVER Drip-off Weight Test Set
The HAVER Drip-off Weight Test Set is used for tests on products in the fish and meat processing industry, tinned fruits and vegetables. After introducing the products the tilting device can be fixed at an angle of inclination of approx. 17° to 20°. In addition a test sieve w 2.80 mm, an intermediate pan and a sieve pan with discharge nozzle belongs to this set.